Ice wash pump

Ice wash pump for vehicles without brand permits Aixam

Origin reference : 8A21 / 820BF021

How does a lava pump work-ice?

The lava pump-ice cream is part of the cleaning system of your bet-break. The rear bezel can also have one. This is the system that sprays the washed liquid-ice on glazing to clean it with ice wiper.

This is the role of the lava pump-ice pumping liquid wash-ice in its tank to put it under pressure and send it to gicleurs. For this, it is located near the lava liquid tank-ice, either below or below.

Lava pump-ice is so under capot, at the engine level. It is often quite easy to access and composed of a single block. Lava pump-ice is also connected on one side to the lava liquid tank-ice, from the other to the wafers plastic pipes, as well as a power supply control by a connector.

The operation of the lava pump-ice is similar to an engine. When you activate the commodo located on your steering wheel to start cleaning the bet-breeze, the electrical terminal of the pump receives this order. It is so actuated and pumps the washed liquid-ice before putting it under pressure. It is then sent to the sprinklers and sprayed on the pare-break.

Good to know there are sometimes two lava pumps-ice cream on a car, one in front and one in the back. They then operate independently. In other cases, the same lava pump-ice cream for the pare-breeze and rear bezel.

When changing a lava pump-ice?

Lava pump-ice has not no defined life. When it fails, it is usually because of a failure of the electric motor. But the lava pump-ice can also fatigue over time, especially if it is subject to frequent use, its tank is not restocked and is used empty, it suffers from severe climatic conditions or because of a leak or gel in the circuit.

If your lava pump-ice is HS, your pare cleaning system-breeze won't work. When you activate the wheel commodo, the wipers-ice action but the liquid wash-ice doesn't come out of the ice cream. Lava pump failure-ice indeed prevents it from reaching the glimpses.

In case of dysfunction of your wash pump-ice, you have no choice but to change it without delay. A lava pump-hS ice prevents your cleaning system from operating, which has a hazardous impact on your visibility flying.

Do not hesitate to do test your lava pump-ice cream, because the dysfunction of the cleaning system can come from scramblers, a disconnected hose, a leak on the circuit or a lack of lava fluid-ice. A lava pump-ice tests by checking his fuse.

How to test a wash pump-ice?

If you want to perform a lava pump test-ice, know that-this will cover the entire system. For that it will have to use the test lamp and control the lava pump fuse-ice. Then put-by connecting the clip to a metal surface in your vehicle.

Note that you will need to be helped by another person to carry out this approach. The-this will have to be done to activate the lava control-ice. Now check the lamp: in case of ignition, the fuse works perfectly well. Otherwise, the one-this is HS and it will be necessary to replace it.

Now test your lava pump-ice by triggering the wash again-ice. Think about it keep a hand at the tank level and ensure-you:

• That the pipe connecting the pump to the spools is not folded;
• That there is no leak under your vehicle.

It will therefore be necessary clean the hose with clear water and bring the gully. If, despite all these attempts, the system washed-ice is always HS, know that the failure actually comes from your wash pump-ice. So you'll have to fix it or change it as soon as possible.